Yes—most permanent wall lights require hard wiring into your home’s electrical circuit. Some wall lights are plug-in or battery/solar powered, but for reliable and compliant installation in bathrooms and external walls, hard wiring by a licensed electrician is typically required.

For outdoor wall lights or wall sconces, a common guideline is to mount the light so its centre is between about 1.5 m and 2.0 m from the ground. This height balances usable illumination without glare and aligns visually with doors or architectural features.

The needed lumens depend on the area and purpose. For general outdoor wall lighting you might aim for 800–1,500 lumens for good visibility. If you’re lighting a pathway or entry, lower lumen levels (e.g. 300–800) can suffice, while security lighting may require more.

First turn off power at the circuit breaker. Remove the trim or cover, disconnect the wiring from the old fixture, attach the new fixture’s wires to the live, neutral and earth points (matching colours), secure the mounting plate, and restore power. Always follow the manufacturer’s wiring diagram and local electrical codes.

Mark mounting points aligned with wall studs or anchors. Drill holes, insert appropriate wall plugs, mount the bracket or plate, and then attach the light fixture. Ensure it’s level and securely fastened before connecting wiring.

Start by isolating the power. Run conduit or cable in a hidden chase to the light’s location. Fix the mounting bracket, pull in wiring, connect wires inside the fixture box, and test before finalising the installation. Use IP-rated fittings outdoors.

Generally wall lights are moderately priced but can incur additional cost due to wiring, mounting and sometimes weatherproofing requirements. However, the design appeal and lighting flexibility often justify the cost for wall mounting.

Yes—if installed correctly with suitable IP (ingress protection) ratings and using correct wiring methods, wall lights can be perfectly safe in external or bathroom environments. Use waterproof fittings, proper insulation and correct earthing for safety.

No, they are relatively low maintenance. Periodic cleaning of the glass or casing, replacing bulbs when needed, and checking seals or fittings for corrosion are typical tasks. For sealed or LED fixtures, maintenance is minimal.

Wall lights are wired into the house’s power circuit. A switch (or dimmer) in the circuit controls on/off or brightness. The fixture gets live, neutral and earth wires. Some modern lights include driver or transformer modules, especially for LED or low-voltage types.

You can shop the full Wall Lights collection on Blue Leaf Bath’s online store with Australia-wide delivery. All purchases are supported by our 30-day returns policy to give you confidence in your purchase.